Embedded System Design using LabView

Embedded System Design using LabView

Course Code:

Course Duration:

40 hours


This course empowers engineering students from all disciplines to build embedded systems, whether it is for the next-generation solar car or for autonomous vehicles. This comprehensive course on embedded systems uses FPGAs, DSPs, MPUs, or any 32-bit microprocessors.

Course Objective

Upon successful completion of the course, participants should be able to:

  • Design embedded systems using field-programmable gate arrays (FPGAs),
  • Design embedded systems using Digital Signal Processors (DSPs), or any 32-bit microprocessors custom design microcontroller programming
  • Prototype using hardware evaluation platforms based on ARM7

Course Outline

The contents of this course are designed to support the course objectives. The following focus areas are included in this course:

  • Module 1: Introduction to Graphical System Design
  • Module 2: Introduction to LabVIEW
  • Module 3: Introduction to Data Acquisition & Signal conditioning
  • Module 4: Introduction to RTOS & FPGA
  • Module 5: Embedded Programming
  • Module 6: Compact RIO
  • Module 7: LabVIEW programming on DSP processor
  • Module 8: LabVIEW programming on ARM Processor
  • Module 9: Holistic Approach to Teach & Learn Embedded Engineering

Course Deliverables

For Faculty

  • Course Material
  • Course Slides
  • Facilitator Guide
  • Student Exercises
  • Case Studies
  • Certification from ICT Academy

For Student

  • Course Material
  • Exercises
  • Case Studies
  • Certification from ICT Academy